Key Takeaway
BRAKES:VACUUM BRAKE SYSTEM by GENERAL MOTORS CORP. was recalled on September 29, 1992. What to do: REPLACE THE BRAKE ASSEMBLY.
BRAKES:VACUUM BRAKE SYSTEM
Description
THE BRAKE PEDAL ASSEMBLY HAS A PUSHROD PIN THAT IS TOO SMALL AND IT IS INSTALLED IN THE WRONG POSITION, CAUSING AN INCREASED BRAKE PEDAL RATIO AND A DECREASED MASTER CYLINDER STROKE.
Injuries / Consequence
THE REDUCED MASTER CYLINDER STROKE RESULTS IN FAILURE TOMEET THE PARTIAL SYSTEM FAILURE REQUIREMENTS OF FMVSS 105, "HYDRAULIC BRAKESYSTEMS". A FURTHER REDUCTION IN BRAKING ABILITY AT A TIME WHEN PARTIAL SYSTEMFAILURE HAS OCCURRED COULD RESULT IN A VEHICLE CRASH.
Remedy
REPLACE THE BRAKE ASSEMBLY.
Products Affected
Vehicle
VehiclesCompany Information
GENERAL MOTORS CORP.
Unknown location
View all 1183 recalls by GENERAL MOTORS CORP. →Related Recalls
STEERING WHEEL FASTENER
April 6, 2011
SOFTWARE IN THE ELECTRONIC CLIMATE CONTROL MODULE
March 7, 2011
REAR SUSPENSION TOE LINK
February 11, 2011
REAR AXLE CROSS PIN FRACTURE
January 11, 2011
REAR AXLE CROSS PIN FRACTURE
December 22, 2010
SAFETY BELT BUCKLE ANCHOR
December 16, 2010
Frequently Asked Questions
Is this recall still active?
Check the status badge at the top of this page. "Ongoing" means the recall is still active and you should follow the remedy instructions. "Completed" or "Terminated" means the recall process has concluded, though the safety issue remains relevant for any unrepaired products.
How do I check if my product is affected?
Compare the model number, lot code, serial number, or date range listed in the recall notice with the information on your product's label or packaging. For vehicles, check your VIN at NHTSA.gov/Recalls.
What remedy is available for this recall?
The listed remedy for this recall is: REPLACE THE BRAKE ASSEMBLY.
Where can I find the original recall notice?
This recall was issued by NHTSA. You can view the original notice using the link provided above.