Key Takeaway
ELECTRICAL SYSTEM:WIRING by FREIGHTLINER CORPORATION was recalled on April 13, 1994. What to do: CORRECT SIZE MOUNTING FASTENERS WILL BE INSTALLED TO REPLACE THE OVERSIZE SCREWS. THESE WILL BE RECESSED INTO THE MOUNTING BLOCK AND CANNOT COME INTO...
ELECTRICAL SYSTEM:WIRING
Description
A LARGER THAN SPECIFIED SCREW WAS USED TO MOUNT A POWER JUNCTION STUD BLOCK TO THE PASSENGER SIDE OF THE ENGINE TUNNEL. THE LARGER SCREW DID NOT ALLOW ADEQUATE CLEARANCE BETWEEN THE SCREW HEAD AND THE RING TERMINALS WHICH ATTACH TO THE STUD. CONTACT BETWEEN THE RING TERMINALS AND THE SCREW HEAD CAN CAUSE AN ELECTRICAL SHORT CIRCUIT.
Injuries / Consequence
ELECTRICAL SHORT CIRCUITS IN THE ENGINE COMPARTMENT CAN LEAD TO POSSIBLE FIRES WITHOUT PRIOR WARNING.
Remedy
CORRECT SIZE MOUNTING FASTENERS WILL BE INSTALLED TO REPLACE THE OVERSIZE SCREWS. THESE WILL BE RECESSED INTO THE MOUNTING BLOCK AND CANNOT COME INTO CONTACT WITH THE RING TERMINALS.
Products Affected
Vehicle
VehiclesCompany Information
FREIGHTLINER CORPORATION
Unknown location
View all 130 recalls by FREIGHTLINER CORPORATION →Related Recalls
FREIGHTLINER/STEERING INPUT SHAFT
September 4, 2003
FREIGHTLINER/CUMMINS/ECM
July 17, 2003
FREIGHTLINER/STERLING/FIFTH WHEELS/FATIGUE CRACKS
June 19, 2003
FREIGHTLINER/ELECTRONIC CONTROL MODULE
June 6, 2003
FREIGHTLINER/THOMAS BUILT/ALTERNATOR CABLE PINCHIN
June 4, 2003
FREIGHTLINER/AIR BRAKES
May 6, 2003
Frequently Asked Questions
Is this recall still active?
Check the status badge at the top of this page. "Ongoing" means the recall is still active and you should follow the remedy instructions. "Completed" or "Terminated" means the recall process has concluded, though the safety issue remains relevant for any unrepaired products.
How do I check if my product is affected?
Compare the model number, lot code, serial number, or date range listed in the recall notice with the information on your product's label or packaging. For vehicles, check your VIN at NHTSA.gov/Recalls.
What remedy is available for this recall?
The listed remedy for this recall is: CORRECT SIZE MOUNTING FASTENERS WILL BE INSTALLED TO REPLACE THE OVERSIZE SCREWS. THESE WILL BE RECESSED INTO THE MOUNTING BLOCK AND CANNOT COME INTO CONTACT WITH THE RING TERMINALS.
Where can I find the original recall notice?
This recall was issued by NHTSA. You can view the original notice using the link provided above.