Key Takeaway
REAR BUMPER HEIGHT NONCOMPLIANCE by AULICK MANUFACTURING, INC. was recalled on September 6, 2011. What to do: AULICK WILL REPLACE THE REAR BUMPER WITH ONE THAT HAS THE CORRECT PLACEMENT AND IS COMPLIANT HEIGHT. THE RECALL BEGAN ON NOVEMBER 11, 2011. OWNERS M...
REAR BUMPER HEIGHT NONCOMPLIANCE
Description
AULICK MANUFACTURING IS RECALLING CERTAIN AULTIMATE AGRICULTURAL TRAILERS MANUFACTURED FROM FEBRUARY 5, 2004, THROUGH JULY 1, 2011, FOR A REAR BUMPER THAT FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NUMBER 224, "REAR IMPACT PROTECTION" AND FEDERAL MOTOR VEHICLE SAFETY STANDARD NUMBER 223 "REAR IMPACT GUARDS." THE BOTTOM OF THE BUMPER EXCEEDS THE MAXIMUM ALLOWABLE HEIGHT FROM THE GROUND, WHICH LIMITS THE UNDERRIDE PROTECTION. ADDITIONALLY, THE PROJECTED VERTICAL HEIGHT OF THE REAR BUMPER IS LESS THAN 100MM.
Injuries / Consequence
IN THE EVENT OF A CRASH, A PASSENGER VEHICLE'S BUMPER MAY TRAVEL UNDER THE TRAILER'S BUMPER. WITHOUT THE PROTECTION THAT THE BUMPER AFFORDS, THE INJURIES TO THE PASSENGERS IN THE VEHICLE MAY BE INCREASED. IN ADDITION, THE IMPACT LOAD DISTRIBUTION MAY BE DECREASED IN THE EVENT OF A CRASH DUE TO NONCOMPLIANT VERTICAL HEIGHT.
Remedy
AULICK WILL REPLACE THE REAR BUMPER WITH ONE THAT HAS THE CORRECT PLACEMENT AND IS COMPLIANT HEIGHT. THE RECALL BEGAN ON NOVEMBER 11, 2011. OWNERS MAY CONTACT AULICK AT 1-308-632-6197.
Products Affected
Vehicle
VehiclesCompany Information
AULICK MANUFACTURING, INC.
Unknown location
View all 1 recalls by AULICK MANUFACTURING, INC. →Related Recalls
Engine Stall Due to Disabled Rear Fuel Pump
March 5, 2026
Tire Sidewall Damage
March 5, 2026
Rearview Camera Image May Not Display
March 4, 2026
Incorrectly Displayed Rearview Camera Image/FMVSS 111
March 4, 2026
Driver's Seat May Move Unexpectedly
March 3, 2026
Driveshaft May Separate
March 3, 2026
Frequently Asked Questions
Is this recall still active?
Check the status badge at the top of this page. "Ongoing" means the recall is still active and you should follow the remedy instructions. "Completed" or "Terminated" means the recall process has concluded, though the safety issue remains relevant for any unrepaired products.
How do I check if my product is affected?
Compare the model number, lot code, serial number, or date range listed in the recall notice with the information on your product's label or packaging. For vehicles, check your VIN at NHTSA.gov/Recalls.
What remedy is available for this recall?
The listed remedy for this recall is: AULICK WILL REPLACE THE REAR BUMPER WITH ONE THAT HAS THE CORRECT PLACEMENT AND IS COMPLIANT HEIGHT. THE RECALL BEGAN ON NOVEMBER 11, 2011. OWNERS MAY CONTACT AULICK AT 1-308-632-6197.
Where can I find the original recall notice?
This recall was issued by NHTSA. You can view the original notice using the link provided above.