Key Takeaway
SUSPENSION:MOTORCYCLE FRONT by BAYERISCHE MOTOREN WERKE was recalled on June 29, 1994. What to do: DEALERS WILL REMOVE THE BEARING PIN, APPLY A STRONGER ADHESIVE AND REASSEMBLE WITH AN INCREASED TORQUE SPECIFICATION. THE FLANGE NUT ON THE FRONT STRU...
SUSPENSION:MOTORCYCLE FRONT
Description
CERTAIN SUSPENSION COMPONENTS CAN LOOSEN WHEN THE MOTORCYCLE IS RIDDEN HARD IN ROUGH OFF-ROAD CONDITIONS. THE RIGHT-HAND BEARING PIN IN THE REAR SWINGING ARM AND ALSO THE LOWER FLANGE NUT ON THE FRONT STRUT CAN BOTH LOOSEN.
Injuries / Consequence
THIS CAN RESULT IN REDUCTION OF THE MOTORCYCLE'S DYNAMIC STABILITY RESULTING IN LOSS OF CONTROL OF THE MOTORCYCLE.
Remedy
DEALERS WILL REMOVE THE BEARING PIN, APPLY A STRONGER ADHESIVE AND REASSEMBLE WITH AN INCREASED TORQUE SPECIFICATION. THE FLANGE NUT ON THE FRONT STRUT WILL BE REPLACED WITH A SELF-TIGHTENING NUT.
Products Affected
Vehicle
VehiclesCompany Information
BAYERISCHE MOTOREN WERKE
Unknown location
View all 143 recalls by BAYERISCHE MOTOREN WERKE →Related Recalls
BMW/DRIVER'S SEAT OCCUPANT DETECTION SYSTEM
August 11, 2004
BMW/FLAT TIRE MONITORING SYSTEM'S PROGRAMMING
July 20, 2004
BMW/ENGINE CONTROL MODULE/ENGINE STALLING
July 14, 2004
BMW/IABS SENSOR CONNECTION
June 25, 2004
BMW\FUEL SUPPLY LINE CLIP
June 25, 2004
BMW\REAR BRAKE MASTER CYLINDER
June 25, 2004
Frequently Asked Questions
Is this recall still active?
Check the status badge at the top of this page. "Ongoing" means the recall is still active and you should follow the remedy instructions. "Completed" or "Terminated" means the recall process has concluded, though the safety issue remains relevant for any unrepaired products.
How do I check if my product is affected?
Compare the model number, lot code, serial number, or date range listed in the recall notice with the information on your product's label or packaging. For vehicles, check your VIN at NHTSA.gov/Recalls.
What remedy is available for this recall?
The listed remedy for this recall is: DEALERS WILL REMOVE THE BEARING PIN, APPLY A STRONGER ADHESIVE AND REASSEMBLE WITH AN INCREASED TORQUE SPECIFICATION. THE FLANGE NUT ON THE FRONT STRUT WILL BE REPLACED WITH A SELF-TIGHTENING NUT.
Where can I find the original recall notice?
This recall was issued by NHTSA. You can view the original notice using the link provided above.