Key Takeaway
Wagner To Replace Seals On Power Paint Rollers by Wagner was recalled on November 16, 1988.
Wagner To Replace Seals On Power Paint Rollers
Description
November 16, 1988 Release # 88-096 Wagner To Replace Seals On Power Paint Rollers WASHINGTON, DC - Wagner Spray Tech Corporation of Minneapolis, Minn., is voluntarily offering free replacement seals, labeling and instructions on certain power paint rollers to correct a potential lid ejection problem on units manufactured between May and November, 1984.Used by do-it-yourself homeowners, the power paint roller consists of a pressure canister connected by hose to paint roller. The can of paint is placed inside the canister, the lid attached, and the paint is driven to the roller under pressure exerted by an electric powered compressor. According to the U.S. Consumer Product Safety Commission (CSPC), the lid may be ejected from the canister with enough force to cause injury. There have been 41 reported incidents of the ejected lids causing facial and eye injuries. Paint rollers involved in the repair program are dates coded E84 through L84 on the bottom of the unit, and were identified as model no. 0155001 on the packaging. Consumers should stop using power paint rollers within the above date codes, and call Wagner toll-free, 1-800-365-7650, or write Wagner Spray Tech Corporation, 1770 Fernbrook Lane Minneapolis, MN. 55447 for a free repair kit. The company will provide two replacement seal rings for the pressure canister, a warning label to be affixed to the lid, and new operating instructions. The Wagner power paint rollers in question were sold nationwide by a variety or retailers, including Sears, Roebuck and Co. under the Craftsman power roller label within the same date codes
Products Affected
Wagner power paint roller seals, labeling and instructions
Related Recalls
Wallpaper Steamers Recall/Repair by Wagner
April 7, 1997
Wagner To Modify Airless Paint Sprayers Against Fire Potential
June 11, 1992
BRAKES:HYDRAULIC:MASTER CYLINDER
February 5, 1980
BRAKES:HYDRAULIC:SHOE AND DRUM WHEEL CYLINDERS
October 12, 1979
BRAKES:WHEEL SENSOR SPEED ROTOR
October 12, 1979
BRAKES:HYDRAULIC:SHOE AND DRUM WHEEL CYLINDERS
October 12, 1979
Frequently Asked Questions
Is this recall still active?
Check the status badge at the top of this page. "Ongoing" means the recall is still active and you should follow the remedy instructions. "Completed" or "Terminated" means the recall process has concluded, though the safety issue remains relevant for any unrepaired products.
How do I check if my product is affected?
Compare the model number, lot code, serial number, or date range listed in the recall notice with the information on your product's label or packaging. For vehicles, check your VIN at NHTSA.gov/Recalls.
What remedy is available for this recall?
Check the remedy section above or contact the manufacturer directly for current remedy options.
Where can I find the original recall notice?
This recall was issued by CPSC. You can view the original notice using the link provided above.